Brake Kit Installation

Uncategorized 1 Minute

The brake kit from Speedway Motors arrived today and while test fitting the disk rotor hat over the axle I discovered that the axle flange was too large to register inside the hat.  The amount need for the parts to fit was only about a 10th of an inch so I took the axles and one of the hats to my trusty machine shop to have the outer diameter of the axles reduced to fit the rotor hats.

Published by oldschoolgasser

I am retired communications engineer with bad hobbies (those that are addicting and expensive. I have been a gear head since high school. Published a short Story in Southern R odder in the early 70's about my gear head frenemy and my 1957 Dodge D500 and his Moms 60 Ford 4 door

Published

Leave a Reply

Fill in your details below or click an icon to log in:

Gravatar
WordPress.com Logo

You are commenting using your WordPress.com account. ( Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. ( Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. ( Log Out /  Change )

Cancel

Connecting to %s