Back to Work on the Gasser

Uncategorized 1 Minute

I will be headed back to Arizona next week and I am going to start on the front axle assembly by designing and fabricating a caliper mount for a disk brake conversion using some tabs that I will weld to the 1/2″ bar stock pieces that have been drilled and tapped to mount the caliber. There is no disk brake conversion kit made for the mid 60’s Chevy G10 van front end so like all hot hods some modification is always needed.IMG_20190420_130716MVIMG_20190420_130709

Published by oldschoolgasser

I am retired communications engineer with bad hobbies (those that are addicting and expensive. I have been a gear head since high school. Published a short Story in Southern R odder in the early 70's about my gear head frenemy and my 1957 Dodge D500 and his Moms 60 Ford 4 door

Published

Leave a Reply

Fill in your details below or click an icon to log in:

Gravatar
WordPress.com Logo

You are commenting using your WordPress.com account. ( Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. ( Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. ( Log Out /  Change )

Cancel

Connecting to %s