The Gasser should be ready to start soon. The fuel pump, carburetor and distributor, ignition coil are on the motor and the spark plugs, spark plug wires, radiator and hoses and ready to install. I will find top dead center on #1 compression stroke and install the plug leads and set 20-30 degrees of initial advance and give it a few bumps with new premium fuel and a shot of starter fluid to see if it will turn over.
401 ci Buick NailHead Compression Check
oldschoolgasser Uncategorized 1 Minute
Published by oldschoolgasser
I am retired communications engineer with bad hobbies (those that are addicting and expensive. I have been a gear head since high school. Published a short Story in Southern R odder in the early 70's about my gear head frenemy and my 1957 Dodge D500 and his Moms 60 Ford 4 door View all posts by oldschoolgasser